GE Profile DPVH880 Manuel D'utilisation Et D'installation page 43

INSTALLING THE PEDESTAL (if desired)
CAUTION
— Due to the size and weight of
these products, and to reduce the risk of personal
injury or damage to the product, TWO PEOPLE ARE
REQUIRED FOR PROPER INSTALLATION.
KIT CONTENTS
Ì 4 Support pads
Ì 4 Mounting screws
TOOLS YOU WILL NEED
Ì Phillips head
screwdriver
Ì 9/16" Open-end wrench
or adjustable wrench
Installation Instructions
Ì Drawer divider
Ì 7 mm Socket wrench
INSTALLATION PREPARATION
Remove the packaging.
The drawer divider is taped at the top of the
shipping carton. Remove the divider and set aside
for final installation.
Flatten the product carton to use as a pad to lay
the washer or dryer down on its side. Continue
using the carton to protect the finished floor in front
of the installation location.
REMOVE THE LEVELING LEGS
1
A Carefully lay the washer or dryer on its side
to access the leveling legs on the bottom of
the appliance.
IMPORTANT: Do not lay the washer or dryer on
its back! Do not remove the shipping bolts on the
back side of the washer. The bolts must remain in
place until the washer is returned to an upright
position.
B Use an open-end wrench to remove the
washer or dryer leveling legs.
Back out and remove
all 4 leveling legs
43