Using Your Sear Burner - KitchenAid 720-0856V LP Instructions D'installation Et Guide D'utilisation Et D'entretien

Lighting the Sear Burner
1. Open the side burner cover. Do not light burners
with the cover on.
2. Do not lean over the grill.
3. Push in and turn the grill control knob to
continuing to hold it in.
IMPORTANT: If burner does not light immediately, turn the
burner knob to OFF and wait 5 minutes before relighting.
34

Using Your Sear Burner

Manually Lighting The Sear Burner
1. Open the hood completely. Do not light burners with the
hood closed.
2. Do not lean over the grill.
/HIGH, while 3. Remove the manual lighting extension (see the following
illustration) and attach a match to the split ring.
4. Strike the match to light it.
5. Hold the lit match close to the sear burner.
6. Push in and turn the control knob to
For the burner closest to the lit match. The burner will
light immediately. When burner is lit. turn knob to
desired setting.
7. Repeat steps 3 through 6 for each burner.
8. Remove the match and replace the manual lighting
extension on the right side panel.
IMPORTANT:
If burner does not light immediately, turn the burner knob to OFF
and wait 5 minutes before relighting.
If any burners do not light after attempting to light them manually,
contact the Customer Service Center. See the "Assistance"
section.
/HIGH.