ELCA GENIO-SFERA.E Manuel D'utilisation page 9

Multi_ING_Man_GenioSFERAE_03
2.4 INFORMATION FOR THE PROPER INSTALLATION OF THE RADIO
REMOTE CONTROL SYSTEM
Installation must be carried out by qualified technicians.
Installation is very important because good Radio Remote Control operation and easy maintenance depend on it.
If requested, two fixing plates are available with the Radio Remote Control system. These plates make installing
the receiving unit on the machine easier, because they offer the choice of fastening the unit in a fixed, or removable
manner.
1. To fasten the device in a removable manner, take the small plate and fix it to the machine. After opening the
receiving unit, fix the big plate to the base of the casing then connect the two plates. In this manner, the
receiving unit is blocked. When the Radio Remote Control is not being used the receiving unit can be moved
and placed in a safe place together with the transmitting unit.
2. To install the device in a fixed manner, secure the big plate to the machine using the 3 pre-drilled holes. Open
the receiving unit and fix the plate to the base of the casing.
The following regulations should be followed when installing:
1. Keep the upper part of the receiving casing (the portion above the "RC Connection" LED) away from metallic
elements
2. The distance between the receiving unit and the floor must be greater than 2 and less than 10 metres.
3. The receiving unit casing must be installed vertically and in a place where it can be easily reached by
technicians, should interventions for repairs be necessary. Technicians must be able to open the casing easily.
4. The receiver mounting area must be free from vibrations. If this is not possible, use rubber vibration dampers.
5. Use a multiple plug for connection between the receiving unit and the machine electric panel. In this manner the
Radio remote control if needed can be easily substituted with the Cable Control.
6. Find the terminal to which the power is to be connected, paying special attention to the indicated tension values.
7. Use cables with suitable sections for the wiring.
8. If the receivers are powered by direct current, connect the ground wire to a proper ground better if directly from
the battery. Do not electrically connect the negative pole to the machine casing.
9. Connect the stop circuit correctly. Avoid any current which is greater than the value of the protection fuse to
circulate around the circuit contacts.
10. After having finished installation, make sure that the stop circuit operates correctly.
11. Verify that all manoeuvres correspond to the respective commands.
Optional fixing plates
- Page 6 -
GENIO-SFERA.E Radio remote control system