Operation Description - ELCA GENIO-SFERA.E Manuel D'utilisation

Multi_ING_Man_GenioSFERAE_03
4. AT GENIO-SFERA.E. TRANSMITTING UNIT
The AT GENIO-SFERA.E transmitting unit is available in the following versions:
Version with single-step joysticks: 2 to 3 single or double axis single-step joysticks plus 5 three-position
•
switches.
Version with multistep joysticks: 2 to 3 multistep single or double axis joysticks (max. 4 steps) plus 5 three-
•
position switches.
Version only with switchs: up to 20 switches.
•

4.1 OPERATION DESCRIPTION

The battery powered transmitting unit allows the user to communicate a sequence of digital data which translates
the selected command to the apparatus being used.
The transmitting unit is made up of two essential parts:
1. Command devices: These are the keys, selectors or joysticks that give commands to the machine, and
include the Stop pushbutton.
2. Digital coding unit and high frequency transmitter: Made up of the digital coding unit, which receives the
address of the transmission telegram read on the connection key, and also commands coming from the
command devices. It generates the transmission telegram and controls the battery charge state, deciding when
to give the battery exhausted signal and when to switch off the transmitting unit (if the voltage is too low). It also
switches off the transmitting unit if the unit is not used for several minutes. The high frequency transmitting part
transmits data via radio. The operating frequency can be set in a fixed manner using the micro-switches
(manual mode) or with an appropriate operative command sequence (automatic mode).
4.2 COMMAND LAYOUT
Refer to the inserts included in this manual.
AT GENIO-SFERA.E transmitting unit
Block diagram showing the transmitting unit
- Page 11 -
GENIO-SFERA.E Radio remote control system