General Information - ELCA GENIO-SFERA.E Manuel D'utilisation

Multi_ING_Man_GenioSFERAE_03 GENIO-SFERA.E Radio remote control system
2. USER INSTRUCTIONS

2.1 GENERAL INFORMATION

General block diagram
The GENIO system of Radio Remote Controls produced by ELCA is a range of low power industrial Radio Remote
Controls which use radio frequency to control lifting and transportation devices.
The GENIO type Radio Remote Control system produced by ELCA has two main parts:
1. The transmitting unit (AT) which allows the user to communicate the digital data sequence which forms the
selected command to the receiver.
2. The receiving unit (AR) which decodes the digital data sequence and transforms it into those electric impulses
needed by the machine to carry out the selected command.
The AT GENIO-SFERA.E transmitting unit can be combined with one of the following receiving units: AR GENIO-
A.E, AR GENIO-D.E, AR GENIO-FLEXI-A.E, AR GENIO-FLEXI-SW.E, AR GENIO-BOARD.E.
With the electromagnetic wave command system, the user is free to move around the machine, indeed no cable
needs to be connected to the transmitting unit therefore the operator can remain at a distance from the machine in
a safe position that is more suitable for controlling machine movements.
Each Radio Remote Control uses a precise radio frequency and a specific transmission telegram that is
programmed exclusively by the manufacturer and cannot be changed. In this manner each transmitting unit
can only work with its own receiving unit and cannot interfere with other Radio remote controls.
The operating frequency can be set in a fixed manner using dip-switches (manual mode) or with a particular
operative sequence of commands (automatic mode).
At the time of printing, permission was granted to issue the products in the markets of the European Community
countries, in accordance with of the 2014/53/EU Directive.
- Page 2 -