Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. Measurement
En
Caution — Controls, adjustments or usage of procedures other than those specified herein may
produce negative effects or damage to your health due to laser radiation.
Es
Fr
1. Preparing
Pt
Install a battery in the battery chamber. (See "Battery")
2. Diopter adjustment
Adjust the diopter to obtain a clear internal display in the viewfinder.
First, rotate the diopter adjustment ring counterclockwise until it comes to a complete stop. Next, rotate the
diopter adjustment ring back and forth until the internal display comes into focus.
3. Measuring
Before measuring, be sure to confirm the Distance display unit setting.
3-1. Turn on the power.
(Automatic power shut-off after
approx. 8 seconds unoperated.)
Standby
Immediately after power-on
12
3-2. Aim at the target.
Position the target at the center of
the target mark.
3-3. Press the POWER ON/Measurement button once to start continuous measurement for approx. 8 seconds.
During measurement, the measured result is displayed consecutively while the laser irradiation mark is
blinking.
After measurement, the result is displayed for approx. 8 seconds, then power automatically turns off.
If you press the POWER ON/Measurement button during power-on, another 8-second continuous
measurement starts.
Example of measured distance
display
When measuring a flagstick at a golf course, for example, keep targeting the
flagstick at the center of the target mark to minimize handshake.
Example of measurement failure
En
Es
Fr
Pt
13
Publicité
Table des Matières
