Navigating The Menus; Changing The Measurement Display Mode (F1) - Nikon COOLSHOT 20i Manuel D'utilisation

Navigating the menus

• Operating the MODE button
There are two ways to press the MODE button. Operate the button while following the descriptions in this manual.
- "Press and hold" means to continue pressing the button for 1.5 seconds or longer.
- "Press" means to press the button quickly (less than 1.5 seconds).
„ Changing the measurement display mode (F1)
„
Slope adjusted distance (horizontal distance ± height) mode and actual distance
mode can be switched. Factory default setting is slope adjusted distance
(horizontal distance ± height) mode.
1. Press the PWR button to turn on the Laser Rangefinder.
2. Press and hold the MODE button.
• You can now change the measurement display mode.
3. The setting switches every time you press the PWR button.
(horizontal distance ± height) mode
• If you press and hold the MODE button or do not operate the buttons for about 8 seconds, the
displayed setting is saved and the Laser Rangefinder returns to standby.
• The setting is saved even when the Laser Rangefinder is turned OFF.
Slope adjusted distance
Slope adjusted
distance (horizontal
distance ± height)
N/A Actual distance mode
N/A
En
Fr
Actual
distance
11