Troubleshooting - Britax B-SAFE 35 Elite Guide D'utilisation

BRITAX Child Safety, Ltd.
Cleaning
Cover/ • Hand wash using
cold water and mild
Canopy
soap
• Line dry
Shell • Sponge clean using
warm water and
mild soap.
• Towel dry
Harness • Sponge clean using
warm water and
mild soap.
• Towel dry
Buckle • Thoroughly rinse the
buckle using warm
water.
• Test the buckle
by fastening and
unfastening until
a click is heard
after inserting each
buckle tongue. If
clicks are not heard,
repeat the cleaning
procedure.
• Towel dry
44
DO NOT
• Bleach
• Machine wash
• Machine dry
• Iron
DO NOT
• Use abrasive
cleaners
DO NOT
• Disassemble
the harness
• Bleach
• Machine Wash
• Machine Dry
• Iron
DO NOT
• Soak
• Lubricate
• Use solvents
• Use soap or
household
detergents

Troubleshooting

Problem: The infant car seat will not
securely attach to the base.
Possible solution: The vehicle belt
buckle stalk may be too long (A).
Consult your vehicle owner's manual to
see if you can lower the vehicle buckle
position by twisting the vehicle buckle
stalk a maximum of three full rotations
to shorten to appropriate length (B).
Be sure the vehicle buckle release is
facing outward after twisting.
Possible solution: Adjust the infant
car seat base to a higher position to
avoid any potential interference with the vehicle belt buckle.
Ensure that the infant car seat recline indicator is in an
allowable position once installed.
Problem: The harness straps do not tighten evenly.
Possible solution: The harness retainer clip (under the seat
cover) is not in the correct location. Remove the seat cover
as shown on page 40 and center the retainer clip.
Problem: The buckle will not fasten with a click after each
tongue is inserted.
Possible solution: There may be debris in the buckle
mechanism. Clean the buckle as described on page 44 and
try fastening the buckle again.
Please contact BRITAX Consumer Services at 1-888-427-
4829 or 1-704-409-1699 if you have an issue not listed here.
B-SAFE 35 ELITE User Guide
A
B
45