Calling The Wake-Up Timer; Cancelling The Wake-Up Timer; Using The Wake-Up Timer; Using The Sleep Timer - Pioneer X-CM31-K Mode D'emploi

04 Getting started

Calling the wake-up timer

It can be used to re-use an existing timer setting.
1 As well as steps 1 through 3 in "Setting the
wake-up timer".
2 Press to select "TIMER ON", then press
ENTER.

Cancelling the wake-up timer

It can be used to turn off the timer setting.
1 As well as steps 1 through 3 in "Setting the
wake-up timer".
2 Press to select "TIMER OFF", then
press ENTER.

Using the wake-up timer

1 Press STANDBY/ON to turn the power
off.
2 At the wake-up time, this unit will turn on
automatically and play the selected input
function.
Note
• If at the wake-up time iPod/iPhone/iPad is not connected
to this unit or a disc is not inserted, this unit will be
turned to on and not play back the track.
• Some discs may not be played automatically at the wake-
up time.
• If you set the timer, take one minute or more between the
start and end time.

Using the sleep timer

The sleep timer switches off the unit after a specified time so
you can fall asleep without worrying about it.
1 Press SLEEP repeatedly to select a switch off
time.
Choose between 10 min, 20 min, 30 min, 60 min, 90 min, 120
min, 150 min, 180 min or OFF. The newly set value displays for
3 seconds, and then the setting is completed.
Note
• The sleep timer can be set by pressing SLEEP while the
remaining time is displayed.
14
En

Using Headphones

Connect to the jack plug of the headphones.
When the headphones are connected, there is no sound
output from the speakers.
PHONES AUDIO IN
• Do not turn the volume on to full at switch on and listen
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
• Before plugging in or unplugging the headphone,
reduce the volume.
• Be sure your headphone has a 3.5 mm diameter plug
and impedance between 16
recommended impedance is 32 .
• Audio from the iPod/iPhone/iPad cannot be heard via
the headphones connected to the unit. "HP MUTE" will
be displayed if you connect the headphones when the
iPod/iPhone/iPad function is selected.
TIMER VOLUME
iPad
and 50 . The