Connecting Antennas; Using External Antennas; Plugging In - Pioneer X-CM31-K Mode D'emploi

Connections

Connecting antennas

Connect the AM loop antenna and the FM wire antenna as
shown below. To improve reception and sound quality,
connect external antennas (see Using external antennas
below).
fig. a
ANTENNA
AM
4
LOOP
FM
UNBAL 75 Ω
1 Connect the AM antenna wires.
Holding the connector to connect.
2 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the direction indicated
by the arrow (fig. a) then clip the loop onto the stand (fig. b).
3 Place the AM antenna on a flat surface and
in a direction giving the best reception.
4 Connect the FM wire antenna into the FM
antenna socket.
For best results, extend the FM antenna fully and fix to a wall
or door frame. Don't drape loosely or leave coiled up.
fig. b
2
1
3

Using external antennas

To improve FM reception
Use a PAL connector (not supplied) to connect an external
FM antenna.
75 coaxial
cable

Plugging in

Before making or changing the connections, switch off the
power and disconnect the power cord from the AC outlet.
After you've finished making all connections, plug the unit
into an AC outlet.
This unit's rear panel
VIDEO LINE SPEAKERS
OUT IN
R
L
R L
To AC outlet
CAUTION
• Do not use any power cord other than the one supplied
with this unit.
• Do not use the supplied power cord for any purpose
other than that described below.
One-touch PAL
connector
ANTENNA
FM
UNBAL 75 Ω
AC IN
Power cord
03
11
En