Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
20) MODE-BUTTON
21) FINE-BUTTON
For moving the joystick with the smallest increment.
Rear panel:
22) Audio input socket
23) MIDI input socket
24) DMX output socket
25) DMX input socket
26) Power supply socket
27) Power switch
28) Remote switch socket
5. SETUP
5.1 Installation
Install the device on a plane surface or install it in rack.
This device is built for 483 mm racks (19"). This rack should be a double-door rack where front panel and
rear panel can be opened. The rack should be provided with a cooling fan. When mounting the device into
the rack, please make sure that there is enough space around the device so that the heated air can be
passed on. Steady overheating will damage your device. You can fix the device with four screws M6 in the
rack. If several devices are to be installed, make sure that you leave 1 unit (1 u) space between the devices.
Connect the connection cable of the power-unit with the DC IN-socket. Plug the power unit into your outlet.
5.2 Sound-control
The sound-control works via the built-in microphone or the Line In socket. Connect the sound-signal from the
mixer (e.g. Master 2) with the RCA-socket on the rear panel (input sensitivity 0.1 V - 1 V).
5.3 DMX-512 connection with the projector
The wires must not come into contact with each other, otherwise
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixtures will not work at all, or will not work properly.
19/46
REMOTE SWITCH
Tip = signal
Sleeve = switch
Ring = 10 V
00042202.DOC, Version 2.2
Publicité
Table des Matières
