Assigning The Fade Time - EuroLite DMX Scan Control Mode D'emploi

Select the desired projector via the Projector Select-buttons. the display shows the Pan/Tilt-value. E.g. "ASS
01 02" means that Pan is assigned to channel 1and Tilt is assigned to channel 2. "RES 01 02" means that
Pan on channel 1 and Tilt on channel 2 is inverted. If only Pan is inverted, the display shows "RES 01 00".

5.4.6 Assigning the Fade Time

With this function, you can determine if the Fade Time should be assigned only for the Pan/Tilt-movement or
for all DMX-channels. This makes especially sense when the mirror or Moving-Head movement should be
carried out slowly, but the gobos and colours should be changed quickly.
Turn the device off.
Press and hold the Mode and Tap/Display-button at the same time.
Turn the device on again. Press the Tap/Display-button in order to switch between the two modes.
ALL CH
OR
FD TIME
All channels
Press the Mode and Tap/Display-button at the same time in order to memorize your settings. Press the
Blackout-button in order to leave the mode without saving.
5.4.7 Fine-function
By pressing the Fine-button (LED lit), the joystick is set to the smallest movement increment.
5.5 Connection of the Remote Switch socket
You can connect analogue-controlled devices, e. g. smoke-machines with low voltage connector to the
Remote Switch socket.
This socket is only meant for low voltage!
The pin occupation of the stereo jack socket is as follows:
Tip = signal
Sleeve = switch
Ring = 10 V
ONLY X/Y
FD TIME
Only Pan/Tilt
21/46 00042202.DOC, Version 2.2