GOLDONI S.p.A.
STARTING AND STOPPING THE
ENGINE
Before starting the engine
WARNING
For machine with an electric starter:
Do not start the engine without having
positioned and properly connect the
battery to prevent damage to the
voltage regulator.
To start the engine, it is advisable to shift the
gears and the PTO shuttle to the neutral position
and leave the Gear Stop
position so as to disengage the clutch.
EN Inglese
lever in the raised
Ignition switch
Insert the key and turn it as described
below:
Position 0
No circuit powered.
Position 1
Insert the key and turn it clockwise to
the first position (the electrical circuit
will be powered).
Position 2
Engine starts.
Each starting attempt should last for just a few
seconds.
Do not make consecutive attempts to start the
engine without having waited at least 20 sec.
between one attempt and the next, otherwise the
battery will quickly run down and the starter motor
could be damaged.
WARNING
Do not keep operating the starter motor
when the engine has already started.
Damage to the starter motor due to
failure
instructions will not be covered by the
warranty.
After the engine has started:
Release the key. It will automatically return
to the operating position
92
MY SPECIAL SR
to
comply
with
OPERATING INSTRUCTIONS
these