Power Take-Off; Power Take-Off (Pto) - GOLDONI MY SPECIAL SR Série Notice D'utilisation Et D'entretien

GOLDONI S.p.A.

POWER TAKE-OFF

Power take-off (PTO)

WARNING
when the PTO is not used, move the
mode selector lever to the Neutral or
Independent position (depending on
the model or version). This prevents
the shaft of the PTO and other spinning
components from accidentally turning.
WARNING
Whenever the PTO is not in use, the
drive shaft must be covered by the
special guard.
The PTO is engaged by means of the PTO
lever and, when the machine is at a standstill,
with the Gear Stop raised.
The tractor is equipped with a rear power take-off
able to function in the following mode:
Independent.
By using the lever
possible:
540 - 890 rpm with 3000 engine rpm
Synchronized
Synchronised with all gears.
These are the revolution of the PTO for every
wheel revolution
Ratio - 4,1: 1
EN Inglese
the following speeds are
Counter-clockwise rotation
Power take-off 26 UNI 220 profile
Implement hitching lever
PTO shaft guard.
IMPORTANT
The two-wheeled tractor is equipped
with a safety device that prevents the
reverse gear from being engaged when
the PTO is engaged, in the normal
operating direction. Set the PTO to the
neutral position before engaging the
reverse gear.
102
MY SPECIAL SR
OPERATING INSTRUCTIONS