Setting Up The Receiver (Setup Mode); Selecting Frequency Groups (Auto Group Setup) - AKG WMS 4000 Mode D'emploi

Masquer les pouces Voir aussi pour WMS 4000:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 44
3 Setting Up
3.8 Setting Up the Receiver
(SETUP Mode)
*Note:
3.8.1 Selecting Frequency
Groups (Auto Group Setup)
28
- If no battery information is received or the information is invalid, the following message appears on
the display:
In SETUP mode, the electronic lock is disabled so you can adjust all receiver parameters. The "LOCK"
label is not shown.
1. To enter SETUP mode, press and hold the SETUP control until the "LOCK" label disappears.
2. Turn the SETUP control CW or CCW to select the desired setup screen. The following setup screens
are available:
- Auto Group Setup
- Auto Channel Setup
- Preset
- Frequency
- Name
- Environment Scan
- Squelch Threshold
- Rehearsal
- Extra
If your system has only a single channel, we recommend using the Auto Group Setup screen (section
3.8.1) to set the frequency.
To set frequencies for a multichannel system, use the Auto Channel Setup screen (section 3.8.2).
3. To return to LOCK mode, press and hold the SETUP control until the "LOCK" label appears on the
display.
1. In SETUP mode, turn the SETUP control CW or CCW as many times as needed to call up this screen:
2. Press the SETUP control briefly. The display will change as follows:
3. Turn the SETUP control CW or CCW to select the number of subchannels you need (e.g., "01" for a
single-channel system, or "14" for a 14-channel system).
4. Press the SETUP control briefly. the display will change as follows:
5. Turn the SETUP control CW to select the next Preset or CCW to select the preceding Preset. The
Preset names are arranged in alphabetical order.
6. Press the SETUP control briefly. The receiver will automatically find a Group with the selected num-
ber of clean frequencies within the selected Preset and tune to the first clean frequency. During the
search, the SETUP control will be disabled, and the display will look like this:
Note:
Clean frequencies are frequencies where the receiver finds no RF signal or an RF signal whose level
is lower than the current threshold setting. (Refer to section 4.3.3.)
for selecting the receiving frequency*

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sr 4000

Table des Matières