Midland BTNEXT PRO Guide D'utilisation page 24

Fixing the microphone
Boom Microphone
Place the section with the Velcro/adhesive strip between the padding and the rigid cover
of the helmet, so that the microphone is correctly positioned in front of your mouth and
that the white symbol is facing your mouth. This type of microphone is suited for Open
Faced and Flip Front helmets.
Wired microphone
Using the Velcro/adhesive strip, place the microphone inside the helmet in front of your
mouth. This type of microphone is more suited for Full Faced helmets. The mini con-
nector on the microphone allows you choose the microphone that best suits the helmet
you are using.
Description of the Slide-in mounting kit
The Midland BTNext PRO can be fixed onto the helmet, installing the slide-in mounting
kit in two different ways: By either using the plate with bi-adhesive strip, or the screw
plate. These methods allow you to safely "fix" the BTNext PRO unit onto your helmet
and to remove it at any time in order to recharge or store it.
22
Plate with bi-adhesive strip
The Bi-adhesive plate is already assembled on the slide-in mounting kit.
Bi-adhesive
Clean the application area on the helmet surface, remove the bi-adhesive film and place
the fixing plate on the left side of the helmet by keeping it contact with the surface for
a few seconds.
Screw Clamp
Step 1. remove the bi-adhesive plate from the slide mount using the allen wrench too
included in the box.
Step 2. Tighten the screw plate to the slide-in mounting kit with the two provided screws.
www.midlandeurope.com