Automatic Heat Up; Powerboost - AEG IAE84411FB Notice D'utilisation

Once the function starts the
indicators above the
come on one after another until
the water reaches the boiling
point.
When the function detects the boiling point
the hob emits an acoustic signal and the heat
level automatically changes to 8.
If all cooking zones are already
in use or there is some residual
heat on all of them, the hob
emits a beep sound, the
indicators above
the function does not start.
To deactivate the function touch
function deactivates and the heat setting
goes down to 0) or touch the control bar and
adjust the heat setting manually.
The Pause function and lifting of
the pot deactivate SenseBoil®.
5.5 Using the cooking zones
Place the cookware in the centre of the
selected zone. Induction cooking zones
adapt to the dimension of the bottom of the
cookware automatically.

5.6 Automatic Heat Up

Activate this function to get a desired heat
setting in a shorter time. When it is on, the
zone operates on the highest setting in the
beginning and then continues to cook at the
desired heating setting.
To activate the function the
cooking zone must be cold.
To activate the function for a cooking
zone: touch (
touch a desired heat setting. After 3 seconds
comes on.
To deactivate the function: change the
heat setting.

5.7 PowerBoost

This function makes more power available to
the induction cooking zones. The function
symbol
blink and
(the
comes on). Immediately
can be activated for the induction cooking
zone only for a limited period of time. After
this time the induction cooking zone
automatically sets back to the highest heat
setting.
Refer to "Technical data"
chapter.
To activate the function for a cooking
zone: touch .
To deactivate the function: change the
heat setting.
5.8 Timer
• Count Down Timer
You can use this function to set the length of
a single cooking session.
First set the heat setting for the cooking
zone, then set the function.
To set the cooking zone: touch
repeatedly until the indicator of a cooking
zone appears.
To activate the function: touch
timer to set the time (00 - 99 minutes). When
the indicator of the cooking zone starts to
flash, the time counts down.
To see the remaining time: touch
the cooking zone. The indicator of the
cooking zone starts to flash. The display
shows the remaining time.
To change the time: touch
cooking zone. Touch
To deactivate the function: touch
the cooking zone and then touch
remaining time counts down to 00. The
indicator of the cooking zone disappears.
When the countdown ends, an
acoustic signal sounds and 00
flashes. The cooking zone
deactivates.
To stop the sound: touch
• CountUp Timer
comes on.
of the
to set
to set the
or .
to set
. The
.
ENGLISH 11