Ryobi TSS121 Manuel D'utilisation page 21

CAUTION:
Always install the blade with the blade teeth and the arrow
printed on the side of the blade pointing down at the front
of the saw. The direction of blade rotation is also stamped
with an arrow on the upper blade guard.
 Tighten blade bolt securely.
 Replace blade bolt cover and tighten blade bolt cover
screw securely.
 Lower the blade guard.
 Raise and lower the saw arm to ensure lower blade guard
functions correctly.
WARNING:
Make sure the spindle lock button is not engaged before
reconnecting saw into power source. Never engage
spindle lock button when blade is rotating.
REMOVING/REPLACING THE THROAT PLATE
See Figure 19.
WARNING:
The throat plate must be below the miter table. If the throat
plate is too high or too low, the workpiece can catch on
the uneven edges resulting in binding which could result
in serious personal injury.
Never operate the saw without a throat plate installed.
To remove/replace:
 Unplug the saw.
 Remove the screws securing the throat plate.
 Lift the throat plate from the saw.
 To reinstall the throat plate, align the holes in the throat
plate with the holes in the saw base.
 Retighten the screws, being careful not to overtighten
which can cause the throat plate to bow or bend.
ASSEMBLY
ADJUSTING SUPPORT FOOT
See Figure 19.
Turn the support foot clockwise or counterclockwise
depending on the amount of support needed for making
sliding cuts.
NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so that
we can clearly show points being made in the illustrations.
Never operate the saw without all guards securely in
place and in good operating condition.
21 − English
THROAT
PLATE
SUPPORT
FOOT
Fig. 19