Ryobi TSS121 Manuel D'utilisation page 29

Once the two correct settings for a particular cut have been
obtained, always make a test cut in scrap material before
making a finish cut in good material.
NOTE: It may be necessary to adjust or remove the sliding
miter fence to insure proper clearance prior to making the cut.
 Slide the saw head to its most rearward position and
tighten the slide lock knob securely.
 Pull out the lock pin and lift saw arm to its full height.
 Loosen the miter lock handle approximately one-half turn
and squeeze the detent release lever.
 Rotate the control arm until the pointer aligns with the
desired angle on the miter scale.
 Release the detent release lever, then tighten the miter
lock knob to secure the miter table.
 Loosen the bevel lock knob and move the saw arm to
the left to the desired bevel angle.
 Bevel angles can be set from 0° to 45°.
 Once the saw arm has been set at the desired angle,
securely tighten the bevel lock knob.
 Recheck miter angle setting. Make a test cut in scrap
material.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board could collapse on the blade at the end of the
cut, jamming the blade. See Figures 42 - 43.
 When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 35.
 Turn the LED switch on.
 Lower the blade and align the cutting line on the workpiece
with the edge of saw blade or the blade shadow.
 Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the trigger lockout
lever and squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
rotating before raising the blade out of workpiece. Wait
until the electric brake stops blade from turning before
removing the workpiece from miter table.
OPERATION
29 − English
COMPOUND MITER CUT
45 X 45 COMPOUND MITER CUT
° °
C-CLAMP
Fig. 33
Fig. 34