Maintenance; Maintenance Schedule - Husqvarna 585 Manuel D'utilisation

Heated handles (592 XPG)
The product has heated front and rear handles. The
electrical heating coils are powered by a generator.
Push the switch in the direction of the arrow to engage
the function. Push the switch in the opposite direction to
disengage the function.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.

Maintenance schedule

Daily maintenance
Clean the external parts of the prod-
uct and make sure that there is no oil
on the handles.
Do a check of the throttle trigger and
throttle trigger lockout. Refer to
a check of the throttle trigger and
throttle trigger lockout on page 25 .
Make sure that there is no damage
on the vibration damping units.
Clean and do a check of the chain
brake. Refer to To do a check of the
chain brake on page 25 .
Do a check of the chain catcher. Re-
To do a check of the chain
fer to
catcher on page 25 .
Turn the guide bar, do a check of the
lubrication hole and clean the groove
in the guide bar. Refer to
check of the guide bar on page 32 .
Make sure that the guide bar and
saw chain are getting sufficient oil.
1471 - 001 - 18.02.2021

Maintenance

Read and understand the
Weekly maintenance
Clean the cooling system. Refer to
To clean the cooling system on page
34 .
Do a check of the starter, starter rope
To do
and return spring.
Lubricate the needle bearing. Refer
To lubricate the needle bearing on
to
page 32 .
Remove burrs from the edges of the
guide bar. Refer to
the front hand guard and the chain
brake activation on page 24 .
Clean or replace the spark arrester
screen on the muffler.
Clean the carburetor area.
To do a
Clean or replace the air filter. Refer
to To clean the air filter on page 28 .
Electrical carburetor heating (592 XPG)
Adjustment of the carburetor heating is done electrically
through a thermostat. This keeps the correct carburetor
temperature and prevents ice in the carburetor.
Monthly maintenance
Do a check of the brake band. Refer
To do a check of the brake band
to
on page 24 .
Do a check of the clutch centre,
clutch drum and clutch spring.
Clean the spark plug. Refer to
amine the spark plug on page 29 .
Clean the external parts of the carbu-
To do a check of rettor.
Do a check of the fuel filter and the
fuel hose. Replace if necessary.
Do a check of all cables and connec-
tions.
Empty the fuel tank.
To ex-
23