To Start The Product - Husqvarna 585 Manuel D'utilisation

WARNING:
working technique can prevent kickbacks.

To start the product

To prepare to start
WARNING:
engaged when the product is started to
decrease the risk of injury.
1. Move the front handguard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up.
a) 585: Set the start/stop switch in choke position.
b) 592 XP, 592 XPG: Set the start/stop switch in
start position.
3. Push the decompression valve (B).
Note:
The decompression valve moves to the
initial position when the product starts.
4. Push the air purge bulb (C) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
A
C
To start the product on page 15 for
5. Continue to
more instructions.
To start the product
WARNING:
a stable position when you start the product.
1471 - 001 - 18.02.2021
Only you and the correct
The chain brake must be
B
You must keep your feet in
WARNING:
idle speed, speak to your servicing dealer
and do not use the product.
1. Put the product on the ground.
2. Put your left hand on the front handle.
3. Put your right foot into the footgrip on the rear
handle.
4. Pull the starter rope handle slowly with your right
hand until you feel resistance.
WARNING:
rope around your hand.
5. Pull the starter rope handle quickly and with force
until the engine starts.
CAUTION:
rope to full extension and do not let go of
the starter rope handle. This can cause
damage to the product.
6. Disengage the choke on 585.
Note:
The choke is disengaged automatically on
592 XP and 592 XPG.
7. Quickly disengage the throttle trigger lockout to set
the product to idle speed.
If the saw chain rotates at
Do not twist the starter
Do not pull the starter
15