To Start The Product - Husqvarna 115iPT4 Manuel D'utilisation

3. Push the lower part of the battery and push it in fully
into the battery holder. The battery locks into position
when you hear a click.
4. Make sure that the latches lock in position correctly.

To start the product

1. Push and hold the start/stop button until the green
LED comes on.
2. Use the power trigger to adjust the speed.
To cut branches
WARNING: Observe great care when
working close to overhead power lines.
Falling branches can result in short
circuiting.
• Whenever possible, position yourself so that you can
make the cut at right angles to the branch.
• Cut large branches in sections so that you have
better control over where they fall. You should also
pay attention to the fact that falling branches can
bounce in the direction of the user after hitting
ground.
12
• Never cut through the swelling at the root of the
branch as this will slow down healing and increase
the risk of fungal attack.
• Use the stop at the base of the cutting head to
provide support during cutting. This will help prevent
the cutting attachment from bouncing on the branch.
• Make an initial cut on the underside of the branch
before cutting through the branch. This will prevent
tearing of the bark, which could lead to slow healing
and cause permanent damage to the tree. The cut
should not be deeper than ⅓ of the branch thickness
to prevent jamming. Keep the chain running while
you withdraw the cutting attachment from the branch
to prevent it jamming.
• Make sure you have a firm footing and that you can
work without being hampered by branches, stones
and trees.
WARNING: Never activate the power trigger
without having the cutting attachment in full
view.
To start the SavE function
The product has a SavE function. The SavE function
gives the longest operation time from the battery.
707 - 003 - 04.03.2019