Husqvarna 115iPT4 Manuel D'utilisation page 17

General information about how to adjust the
depth gauge setting
The depth gauge setting (C) decreases when you
sharpen the cutting tooth (A). To keep maximum cutting
performance you must remove filing material from the
depth gauge (B) to receive the recommended depth
Technical data on page 21 for
gauge setting. See
instructions about how to receive the correct depth
gauge setting for your saw chain.
WARNING: The risk of kickback increases if
the depth gauge setting is too large!
To adjust the depth gauge setting
Before you adjust the depth gauge setting or sharpen
General information about how to
the cutters, refer to
sharpen the cutters on page 16 , for instructions. We
recommend you to adjust the depth gauge setting after
each third operation that you sharpen the cutting teeth.
We recommend that you use our depth gauge tool to
receive the correct depth gauge setting and bevel for the
depth gauge.
1. Use a flat file and a depth gauge tool to adjust the
depth gauge setting. Only use Husqvarna depth
gauge tool to get the correct depth gauge setting and
bevel for the depth gauge.
2. Put the depth gauge tool on the saw chain.
Note: See the package of the depth gauge tool for
more information about how to use the tool.
3. Use the flat file to remove the part of the depth
gauge that extends through the depth gauge tool.
707 - 003 - 04.03.2019
A
C
B
To adjust the tension of the saw chain
WARNING: A saw chain with an incorrect
tension can come loose from the guide bar
and cause serious injury or death.
A saw chain becomes longer when you use it. It is
important to adjust the tension of the saw chain regularly
to make sure that it is correct. Do a check of the tension
of the saw chain before you operate the product. Tighten
the saw chain as tightly as possible, but it must be
possible to pull the saw chain around freely by hand.
Note: A new saw chain has a running-in period. Do a
check of the tension more frequently during this period.
1. Turn the locking knob counterclockwise to unlock the
chain tension adjuster.
2. Turn the chain tension adjuster clockwise to tighten
the saw chain. Apply as much tension to the saw
chain as possible. It must be tight against the guide
bar.
3. Make sure that you can pull the saw chain around
freely by hand and that it does not hang from the
guide bar.
4. Turn the locking knob clockwise to lock the chain
tension adjuster.
To lubricate cutting equipment
WARNING: Poor lubrication of cutting
equipment may cause the chain to snap,
which could lead to serious, even fatal
injuries.
WARNING: Do not use waste oil! Waste oil
is dangerous for persons, the product and
for the environment.
17