Starting The Hydromassage - Teuco HYDRO BASIC 543 Manuel De L'utilisateur

STARTING THE HYDROMASSAGE

(BASIC E - BASIC G)
- When in standby mode, the panel is lit at low
intensity.
- To start the hydromassage function, press
the HYDRO key.
- The hydromassage will start up and the HYDRO
key will light up at high intensity and the SANITIZE
key will switch off.
- After 30 minutes, the hydromassage function will
switch off automatically.
- To stop the hydromassage, press the HYDRO key
again.
- The panel will return to standby mode.
- If the HYDRO key is flashing, this means that there
is not enough water in the tub. The hydromassage
will not work until the water level is sufficient.
During hydromassage operation, it is possible to use the botanical cosmetic products made by
Teuco. Do not use soaps, bath oils or foaming products.
BASIC
EN
30min.
9