Automatic Sanitizing - Teuco HYDRO BASIC 543 Manuel De L'utilisateur

EN

AUTOMATIC SANITIZING

(BASIC E)
- Get out of the tub.
- When in standby mode, the panel is lit at low
intensity.
- To start the sanitizing, press the SANITIZE key.
- The sanification process will start, the
SANIFICATION button will light up at high
intensity and the HYDRO button will switch off.
- After 10 minutes, the sanification process will
stop automatically and the panel will return to
stand-by mode.
- To stop the sanitizing process press the
SANITIZE key again.
- The display will go back to standby.
- After these operations, empty the tub.
If the level of the sanification product is low, the SANIFICATION button will flash at high intensity
and low frequency for 30 seconds during the hydromassage start up stage. If the sanitizer is
finished, the SANITIZE key will continue to flash and the sanitizing process will not commence.
Press a key to return to standby and top up the sanitizer (see DIAGNOSTIC MESSAGES).
12
10min.
BASIC