Operation; Getting Started; The Oled Touch Control Panel; Turning On The Panel - Teuco SEASIDE T07 Manuel D'utilisation

EN

5. OPERATION

GETTING STARTED

Turn on the electricity supply
Set the main switch provided during installation to "ON". The display switches to STAND-BY mode.
Fill up the bathtub
Fill the bathtub until the water level is at least 10 cm above the suction valve. If the level is insufficient, the
display will indicate you need to add more water for the product to operate correctly.

THE OLED TOUCH CONTROL PANEL

5 operating areas
How touch controls work
1 2 3 4 5
The control area is made with capacitive touch
sensors. To activate a function, simply touch the
area concerned with the tip of your finger.
The response of the control areas is subjective,
because it depends on your skin's characteristics,
which differ from one person to the next. Other
non conductive objects cannot be used to activate
functions.
Operation is optimised to avoid accidental activation
due to water (hand shower, cleaning cloth or
The touchscreen control panel is split horizontally into 5 areas,
sponge), but this may still occasionally occur.
which represent 5 buttons.
The buttons are represented by backlit icons which vary
If the surface of the control panel gets wet, wipe
depending on the function
off any excess water with your hand and proceed
with use.

TURNING ON THE PANEL

Teuco
When you turn the product on, the Teuco logo
appears and, where necessary, the check screen
which checks the status of the product.
Stand-by
After a certain period of inactivity, the screen is
turned off completely.
Simply touch any of the sectors to return to the
home screen.
Touch any sector again to go to the MAIN MENU.
Check screen
19