General Notes - Safety Requirements - Teuco SEASIDE T07 Manuel D'utilisation

3. GENERAL NOTES - SAFETY REQUIREMENTS

This manual is an integral part of the product and should be kept for future reference. The same manual
is also available in the download area of the www.teuco.com website.
This manual provides a guide for safe use of the product, and must be read in its entirety before using this product.
For correct use of the product, comply with the instructions given in this manual. This product can be used only for the
purpose for which it was designed. The manufacturer is not liable for any damage resulting from improper use.
The equipment is suitable for use in indoor environments and for domestic use, as well as in public environments such
as hotels, spas, etc.
This equipment can be used by children over the age of eight and persons with reduced physical, sensory or mental
capabilities, or with insufficient experience and knowledge, provided that they are monitored or that they have been
instructed on the safe use of the equipment and are aware of the risks involved.
Children should not play with the equipment, nor carry out cleaning and routine maintenance operations without
supervision.
The first use of the whirlpool bath should not last for more than a few minutes.
The time may be gradually increased with subsequent use. In special cases (the elderly, people suffering from high blood
pressure, heart patients, people with a pacemaker, pregnant women), medical advice should be sought on use of the
equipment.
While enjoying the whirlpool do not use bubble bath or other foaming agents, these should only be used for normal
cleansing bathing.
While using the whirlpool, do not block the inlet nozzle of the recirculating water with objects or with your body, in
particular avoid letting your hair come close to it.
Do not block the air vents on the inspection panel for built-in bathtubs, nor the space between the floor and the side
panels of free-standing bathtubs.
When the unit is not in use, disconnect the power supply by means of the omnipolar switch located between the unit and
the power network.
Should it be necessary to replace the power cord, this should only be done by qualified technical staff.
Lamps and lighting units must be replaced exclusively by Teuco staff.
In case of failure or malfunction of the product or for extraordinary maintenance, contact only Teuco staff. The manufacturer
is not liable for any damage caused by products tampered with or incorrectly repaired.
For all operations/interventions not expressly indicated in this manual, you should contact authorised Teuco technical
service centres.
The data and the features indicated in this manual are not binding on Teuco S.p.A. which reserves the right to make any
modifications it believes appropriate without the obligation of prior notice or replacement.
EN
17