Locations And Functions Of Parts; Front Panel - Sony HSR-X216 Mode D'emploi

Locations and Functions of Parts

Front Panel

5 MONITOR 2 button and indicator
4 OPTION button and indicator
3 QUAD button and indicator
2 MULTI button and indicator
1 POWER indicator
POWER
ALARM
ALARM FULL
FULL
qh FULL indicator
qg ALARM FULL indicator
qf ALARM indicator
1 POWER indicator
Lights in green when the power is applied to the unit
and goes dark when the power is disconnected.
It flashes in red if any problem occurs with the hard-
disk drive or fan.
Note
In order to keep the unit internal temperature low, a
fan is provided on the side of the unit. If the fan does
not operate properly, the POWER indicator will flash
to indicate a problem. Unplug the unit from the power
supply and check to make sure nothing is obstructing
the fan. If after the power is restored to the unit, the
POWER indicator still flashes, do not use the unit and
consult your dealer.
2 MULTI (Multi screen) button and indicator
When you press this button, the monitor changes to
split-screen display.
3 QUAD (4-division screen) button and indicator
When you press this button, the monitor enters 4-
division mode. With each subsequent press of this
button, the next 4 pictures are displayed.
6 ALARM RESET button
MULTI QUAD OPTION MONITOR 2
ALARM RESET
1 2 3 4 5 6 7 8
INPUT
SELECTOR
9 10 11 12 13 14 15 16
DIGITAL SURVEILLANCE RECORDER HSR-X216P
qj INPUT SELECTOR
buttons and indicators
7 LOCK indicator
8 Record/Playback buttons
9 MENU button
q; EXIT/OSD button
qa SHUTTLE HOLD button and indicator
qs Shuttle dial
SHUTTLE
-
l ALARM L HOLD
LOCK
PRE REVERSE PLAY
MENU EXIT/OSD
S PAUSE s STOP G PLAY
ZOOM SEARCH
REC SEQUENCE COPY
a REC
TIMER
STOP
ws Menu reset button
wa COPY button and indicator
w; SEARCH button
ql SEQUENCE button and indicator
qk ZOOM button and indicator
4 OPTION button and indicator
When you press this button in a 9 or 16-division mode,
the indicator begins to flash, and the lower-right part
of the monitor screen is used as the option screen. In
this case, the display is 6- or 13-picture tiled.
5 MONITOR 2 button and indicator
When you press this button, the indicator lights, and
the unit enters Setup mode for the submonitor
connected to the MONITOR 2 connector.
When you press the button again, Submonitor Setup
mode is released.
6 ALARM RESET button
When you press this button in alarm status, the alarm
indications are all reset.
7 LOCK indicator
Lights in red when the security lock function is active.
When you press an operation button with this indicator
lit, the indicator flashes, and a message is displayed to
prompt you to enter a password.
For details on the security lock and password, see "Security
Lock Settings" on page 66(GB).
qd Jog dial
PUSH
wd PC card slot
9
(GB)