Ac Power Cord; Remote Control Unit; Battery Installation - Teac GF-680 Manuel Du Propriétaire

CAUTION
Turn off the power of all the equipment before making
connections.
Read instructions of each component you intend to use with
this unit.
< Be sure to insert each plug securely. To prevent hum and
noise, do not bundle the connection cords with the power
cord.
A
FM antenna
While in FM mode, tune in an FM station and extend the lead
to find the best position for reception. This antenna may
need to be repositioned if you move your unit to a new
location.
B
AUX
You can connect a DVD player, VCR etc. to this unit.
Connect the component with RCA pin cords. Make sure to
connect the white plug to the white jacks (Left) and the red
plug to the red jacks (Right).
C

AC Power Cord

Plug this AC power cord into an AC wall socket.
D
RESET
In the following cases, function buttons may not work
properly.
• When the system is damaged by some electrical shock.
• When the power is irregular or has electrical noises.
In these cases, press the RESET switch once or twice with a
pencil or a ball-point pen lightly.

Remote Control Unit

The provided Remote Control Unit allows the unit to be operated
from a distance.
When operating the remote control unit, point it towards the
REMOTE SENSOR on the front panel of the unit.
< Even if the remote control unit is operated within the effective
range, remote control operation may be impossible if there are
any obstacles between the unit and the remote control.
< If the remote control unit is operated near other products
which generate infrared rays, or if other remote control
devices using infrared rays are used near the unit, it may
operate incorrectly. Conversely, the other products may
operate incorrectly.

Battery Installation

1 2
1 Remove the battery compartment cover.
2 Insert two "AAA" (R03, UM-4) dry batteries. Make sure that the
batteries are inserted with their positive "+" and negative "_"
poles positioned correctly.
3 Close the cover.
Battery Replacement
If the distance required between the remote control unit and main
unit decreases, the batteries are exhausted. In this case replace
the batteries with new ones.
Precautions concerning batteries
< Be sure to insert the batteries with correct positive "+" and
negative "_" polarities.
< Use batteries of the same type. Never use different types of
batteries together.
< Rechargeable and non-rechargeable batteries can be used.
Refer to the precautions on their labels.
< When the remote control unit is not to be used for a long time
(more than a month), remove the batteries from the remote
control unit to prevent them from leaking. If they leak, wipe
away the liquid inside the battery compartment and replace the
batteries with new ones.
< Do not heat or disassemble batteries and never dispose of old
batteries by throwing them in a fire.
3
9