Insignia NS-RTV32 Guide D'utilisateur page 12

NS-RTV32 32-inch MTS Stereo Color TV
• On timer, Off timer, Sleep time (if preset)
• Picture size
3 Press -/DISPLAY again to clear the call
display.
Viewing the previous channel
The QUICK VIEW button allows you to go back
to the last channel viewed. Press QUICK VIEW
again to return to the last channel you were
watching.
Muting the volume
Press MUTE to turn off the sound. The
television's sound is silenced and MUTE
appears on the screen. The sound can be
switched back on by pressing this button again
or by pressing one of the VOL + or – buttons.
Using sleep
To set the television to turn off after a preset
amount of time, press SLEEP on the remote
control. The clock counts up ten (10) minutes for
each press of the SLEEP button (0h00m,
0h10m, ...1h50m, 2h00m).
After the sleep time is programmed, the display
appears briefly every ten minutes to remind you
that the sleep timer is operating. To confirm the
sleep timer setting, press SLEEP and the
remaining time is displayed for a few seconds. To
cancel the sleep timer, press SLEEP repeatedly
until the display turns to 0h00m.
Setting the V-Chip
An age limitation can be set to restrict children
from viewing or hearing violent scenes or
pictures that you may choose to exclude. The
restriction applies to TV rating and movie rating
if this data is transmitted. You may set this
restriction separately. To use the V-Chip
function, you must set a password.
Notes • The V-Chip function is activated only
on programs and input sources that
have the rating signal.
• It may take several minutes to
complete the initial V-Chip setup.
• The V-CHIP SET (DTV) will only be
selectable when the TV receives a
digital broadcast using the new rating
system. Currently, some stations are
still not providing this signal. If the
signal is not provided, V-CHIP SET
(DTV) function will not be available.
• If you forget the password, contact
Customer Service at 1-877-467-4289
for assistance. Your original remote
control is required.
• To avoid forgetting the password, write
it down and keep it in a safe place.
Setting a password
To set a password:
1 Press MENU. The menu screen appears.
2 Press or to select the LOCKS menu.
3 Press or
entering mode.
4 Select and enter a password (4 digits) using
the number buttons (0-9), then press ENTER.
5 Enter the same password again to confirm,
then press ENTER.
The password is now set and the V-Chip
menu appears on the screen.
to display the password
www.insignia-products.com
Setting the V-Chip
To set the V-Chip:
1 Press MENU. The menu screen appears.
2 Press or to select the LOCKS menu.
3 Press or
entering mode. Use number buttons (0-9) to
enter your password, then press ENTER.
The LOCKS menu appears.
4 Press or
press . The V-CHIP SET menu appears.
5 Press or
press or to display the desired rating.
OFF—TV RATING is not set
TV-Y—All children
TV-Y7—7 years old and above
TV-G—General audience
TV-PG—Parental guidance
TV-14—14 years old and above
TV-MA—17 years old and above
When you select TV-Y7, TV-PG, TV-14, or
TV-MA, press -/DISPLAY to further define the
rating. Press
rating you want. Press
setting ON or OFF.
6 Press or
. The RATING menu appears.
then press
7 Press or
press or to select ON or OFF for each
rating.
G—All ages
PG—Parental guidance
PG-13—Parental guidance less than 13
years old
R—Under 17 years old parental guidance
suggested
NC-17—17 years old and above
X—Adult only
8 Press MENU twice to return to the LOCKS
menu, then press
9 Press or to select ON. Your settings are
now set into memory.
10 Press EXIT to return to the normal screen.
Watching a protected show
To watch a program that is blocked by the
V-Chip:
1 Press MUTE.
2 Enter the password, then press ENTER.
After you enter the password correctly, the
protection is temporarily overridden. If the
television is turned off, or if the channel is
changed, the V-Chip restriction is reactivated.
Changing the password
To change the password:
1 Press MENU. The menu screen appears.
2 Press or to select the LOCKS menu.
3 Press or
entering mode. Use the number buttons (0-9)
to enter your password, then press ENTER.
The LOCKS menu appears.
to display the password
to select V-CHIP SET, then
to select TV RATING, then
or to select the desired
or to select the
to select MOVIE RATING,
to select the rating, then
or to select V-CHIP.
to display the password
11