Table des Matières
Publicité
English
Technical Information
Water pressure
Recommended
Maximum
Hot water temp.
Recommended 120°-140° F (48° - 60° C)*
Maximum
Max. flow rate
31060xx1, 31020xx1
04531000
31012xx1
31261XX1
Hole size in mounting surface
Max. depth of mounting surface
* Please know and follow all applicable local plumb-
ing codes when setting the temperature on the water
heater.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that
you have all tools and supplies needed to
complete the installation.
• The hot and cold supply hoses included with this
faucet are for use with ⅜ stops. If your stops are
a different size, purchase adapters at your local
plumbing supply store or home center. Adapters
are not available from Hansgrohe.
• 31261XX1 only: The discharge water
temperature from a bidet fitting shall be limited
to a maximum temperature of 110ºF (43ºC) by
a water temperature limiting device conforming
to ASSE 1070.
2
15 - 75 PSI (0.1 - 0.5 MPa)
145 PSI (1 MPa)
158°F (70° C)*
1.2 GPM (6.6 L/min)
1.0 GPM (3.8 L/min)
0.5 GPM (1.9 L/min)
2.2 GPM (8.3 L/min)
1⅜" (34 mm)
1⅝" (40 mm)
• The drain is suitable for most, but not all, lavatory
sinks sold in the United States and Canada.
• The drain is intended for use in a sink with an
overflow. If your sink does not have an overflow,
or if this drain is too small for the hole in your
sink, please refer to the instructions
included with the sink. Some sinks include
special drain installation instructions and/
or parts. Others require the use of a specialty
drain. Hansgrohe is not respnsible for the cost of
a specialty drain.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
Table des Matières
