Safety Devices; Safety And Information Signs - Angelo Po 0G1FR7G Manuel D'utilisation Et D'installation

SAFETY DEVICES

Although the appliance is complete with all safety
devices, during installation and connection addi-
tional devices must be added if necessary to com-
ply with the relevant legal requirements.
The illustration shows the position of the devices.
A)Gas supply tap: for turning the connection to the
gas supply line on and off.
B)Safety thermocouple: cuts out the gas supply if the
flame goes out
C)Safety thermostat: cuts off the gas supply in case of
overheating
Caution - warning
Make a daily check that the safety devices are
properly installed and in good working order.

SAFETY AND INFORMATION SIGNS

The illustration shows the position of the signs fitted
on the appliance.
A)Nameplate with manufacturer and appliance
data
B)General hazard: read the manual carefully before
carrying out any procedure.
C)General hazard: when washing the appliance do
not point pressurised water jets at internal parts.
D)General hazard: all relevant regulations must be
complied with. "Install in compliance with the rele-
vant regulations and use in well ventilated premises
only".
E)General hazard: all relevant regulations must be
complied with. "No liability is accepted in case of fail-
ure to comply with the installation and commission-
ing instructions".
F) Burn hazard: watch out for hot surfaces.
G)CE mark plate: indicates that the appliance con-
forms to the standard.
C
B
C
A
- 5 -
A
IDM-39618900300.tif
D F
E
G
C
IDM-39618900400.tif
IT
GB
DE
FR
ES
B
English