Guarantee Card - SCHÜTTE 60530 + 60531 Instructions De Montage

Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.
Technical data
Overhead shower: approx. 30 x 30 cm
Hand shower: approx. 8 x 25 cm
Shelf: approx. 35 x 5 cm
Shower bar: approx. 80-120 cm
Shower hose: approx. 150 cm,
kink-resistant, 1/2"
(Ø approx. 1,9 cm)
standard connection
Thermostatically controlled mixer
• Flow pressure: recommended 1.5 bar; install a
pressure reducer at more than 6 bar
• Water temperature: max. 80 °C
Installation Instructions
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incorrect
installation - in particular for subsequent
damages!
Note: A 23 mm spanner is required for the
installation of the shower hose.
Please do not use a pipe wrench!
 Shower settings
Use the diverter (14.2) to set which shower
mode is activated (overhead shower (6) or
hand shower (7)).
The slope of the overhead shower can be
set as desired by the user.
Instructions for care
Sanitary taps require special care. Therefore,
please observe the following instructions:
• Chrome-plated surfaces are sensitive to lime-
dissolving agents, acidic cleaning agents and
all kinds of abrasives.
• Never clean coloured surfaces with abrasive,
corrosive, or alcoholic agents.
• Only clean your taps with clear water and a
soft cloth or a shammy.
Maintenance
• Please observe that the upper part of the
valve and the thermostat element are wear
parts, and that these may have to be replaced
in case of hard water or dirty water every 1-2
years.
• Please check all joints and connections for
leaks or visible damages at regular intervals.
• In case of any leaks or visible damages to
the fitting or connection hoses, these should
be immediately checked by a specialist and
replaced if necessary.
Decommissioning
• Cut off the water supply before dismantling
the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order
of the assembly instructions.
 The illustrations are to be considered as
figurative representations, deviations of
the product are possible. Subject to
technical modifications.

GUARANTEE CARD

Franz Joseph Schütte GmbH assumes a
manufacturer's warranty for the fittings you
have purchased in accordance with the war-
ranty conditions on our website. Your warranty
claims arising from the purchase agreement
with the Seller, as well as your statutory rights
are not limited by this warranty.
17