Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Technical data
Overhead shower: approx. 20 x 20 cm
Hand shower:
Shelf:
Shower bar:
Shower hose:
Single-lever mixer
• Flow pressure: recommended 1.5 bar; install a
pressure reducer at more than 6 bar
• Water temperature: max. 80 °C
Installation Instructions
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incor-
rect installation - in particular for subsequent
damages!
Note: A 23 mm spanner is required for the
installation of the shower hose.
Please do not use a pipe wrench!
 Shower settings
Use the diverter (15.3) to set which shower
mode is activated (overhead shower (3) or
hand shower (8)).
The slope of the overhead shower can be
set as desired by the user.
Instructions for care
Sanitary taps require special care. Therefore,
please observe the following instructions:
• Chrome-plated surfaces are sensitive to lime-
dissolving agents, acidic cleaning agents and
all kinds of abrasives.
• Never clean coloured surfaces with abrasive,
corrosive, or alcoholic agents.
• Only clean your taps with clear water and a
soft cloth or a shammy.
approx. 6.4 x 25 cm
approx. 35 x 10.5 cm
approx. 106 cm
approx. 150 cm,
kink-resistant,
1/2" (Ø approx. 1.9 cm)
standard connection
• Please make sure that no detergent is allowed
to enter the cartridge enclosure as this can
cause the lever to become stiff and cause
noises.
Maintenance
• Please note that a cartridge is an expendable
part and that the cartridge may need to be
replaced every 1-2 years if the water has high
levels of limescale or dirt.
You will find illustrated instructions on how
to replace the cartridge on our website under
the following link: web.fjschuette.de/
Austausch_Kartusche-Ventiloberteil.pdf
• Please check all joints and connections for
leaks or visible damages at regular intervals.
• In case of any leaks or visible damages to
the fitting or connection hoses, these should
be immediately checked by a specialist and
replaced if necessary.
Decommissioning
• Cut off the water supply before dismantling
the product.
• Pay attention to escaping residual water.
• Disassemble the product in the reverse order
of the assembly instructions.
 The illustrations are to be considered as
figurative representations, deviations of
the product are possible. Subject to
technical modifications.

GUARANTEE CARD

Franz Joseph Schütte GmbH assumes a
manufacturer's warranty for the fittings you
have purchased in accordance with the war-
ranty conditions on our website. Your warranty
claims arising from the purchase agreement
with the Seller, as well as your statutory rights
are not limited by this warranty.
18

Publicité

Table des Matières
loading

Table des Matières