Disposal; Technical Specifications; Warranty/Service - Beurer Signature BF 400 Mode D'emploi

Display
BF - - -

11. Disposal

Empty, completely flat batteries must be disposed of through specially designated collection boxes, recy-
cling points or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead
Cd = Battery contains cadmium
Hg = Battery contains mercury
For environmental reasons, do not dispose of the device in the household waste at the end of its service
life. Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
Dispose of packaging in an environmentally friendly manner.

12. Technical specifications

Model:
Dimensions:
Weight:
Measurement range:
Subject to technical changes.

13. Warranty/service

Beurer GmbH, Söflinger Straße 218, 89077 Ulm, Germany (hereinafter referred to as "Beurer") provides a
warranty for this product, subject to the requirements below and to the extent described as follows.
The warranty conditions below shall not affect the seller's statutory warranty obligations which
ensue from the sales agreement with the buyer.
The warranty shall apply without prejudice to any mandatory statutory provisions on liability.
Beurer guarantees the perfect functionality and completeness of this product.
The worldwide warranty period is 5 years, commencing from the purchase of the new, unused product
from the seller.
The warranty only applies to products purchased by the buyer as a consumer and used exclusively for
personal purposes in the context of domestic use.
German law shall apply.
During the warranty period, should this product prove to be incomplete or defective in functionality in
accordance with the following provisions, Beurer shall carry out a repair or a replacement delivery free of
charge, in accordance with these warranty conditions.
If the buyer wishes to make a warranty claim, they should approach their local retailer in the first
instance: see the attached "International Service" list of service addresses.
Cause
BIA measurement not possible. Please repeat the measurement barefoot, or
BF 400
31 x 31 x 2.8 cm
2170 g
5-200 kg
22
Solution
with the soles of the feet lightly dampened
if necessary. Remain on the stainless steel
electrodes after weight measurement, until
the body analysis values are displayed.
20
PAP
BF 410
35 x 30 x 2.8 cm
2660 g