Refueling And Storage Of Fuel Cylinders; Operator Responsibility - Nilfisk PBU 56384165 21KACAT Manuel D'utilisation

For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
This machine is manufactured for commercial use only.
This machine is designed and manufactured for indoor use in
burnishing wax coated hard floor surfaces. Nilfisk-Advance
does not recommend use of this machine in any
environment other than an indoor environment. This propane
powered floor machine is designed and manufactured for
commercial floor burnishing only. This machine is designed to
burnish most modern types of floors including composition tile,
stone, marble, terrazzo, and resilient floor covering, and some
coated wood floors. Even though NFPA 11.13.2.3 says..."the
use of floor maintenance machines in buildings frequented
by the public, including the times when such buildings are
occupied by the public, shall require the approval of the
authority having jurisdiction." Nilfisk-Advance suggests usage
when occupancy of a given work area is minimal.
These machines should not be used
l In nursing homes, hospitals, day-care centers, etc. that are
occupied.
l By unqualified or untrained personnel.
l Unless properly maintained and adjusted.
l On areas with obstructions such as thresholds, floor outlet
boxes, etc.
l In areas where loose debris or other objects are present.
l In rooms and areas without proper ventilation.

Refueling and Storage of Fuel Cylinders

This machine uses a 20lb (9.1kg) capacity aluminum or steel
cylinder, which meets the DOT 4E240 standards. These
cylinders are also listed by UL. In addition, the steel cylinder
meets European TPED specifications and is CE compliant.
Filling should be done ONLY by a qualified propane dealer.
FILL THROUGH THE SERVICE VALVE ONLY. A properly
filled cylinder should not exceed 80% of the rated capapcity.
DO NOT attempt cylinder repair. Return the cylinder to your
propane dealer if repair is necessary. Please note that DOT
regulations prohibit shipping of cylinders after the cylinder has
been filled with propane. When not in use, cylinders should
always be stored outside in an upright position in a secure,
tamper-proof, steel mesh storage cabinet. The cabinet may be
located next to the building, but with at least five feet (1.5 m)
of space between the cabinet and the nearest building opening
(door or window). The cylinder to be used on this machine is
a vapor withdraw cylinder. A liquid withdraw cylinder is not
to be used with this machine. The use of a liquid withdraw
cylinder on a vapor withdraw system could freeze the regulator
and create a fire hazard. The National Fire Protection
Association (NFPA) Standard for Storage and Handling of
LP Gas is the appropriate authority for safe propane use. A
copy of this publication is available through the National Fire
Protection Association (1-800-344-3555) or www.NFPA.org.
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net

Operator Responsibility

The operator is responsible for performing the recommended
daily maintenance and checkups of the machine to keep it in
good working condition. The operator must inform the service
mechanic or supervisor when recommended maintenance
procedures are required as described in the "MAINTENANCE"
section of this manual.
l Read this manual carefully before operating this machine.
l FOR SAFETY: DO NOT operate machine before reading
and understanding the operation manual.
l Check the machine for shipping damage.
Keep your machine regularly maintained by following the
maintenance information in this manual. Order parts and
supplies only from an Authorized Nilfisk-Advance Distributor.
Use the parts illustration section of your manual when ordering
parts. During and after operation, perform the recommended
daily and hourly procedures outlined in the Maintenance Chart.
A9