Machine Preparation; Unpacking The Machine; Filling The Lp Cylinder; Installing The Lp Cylinder - Nilfisk PBU 56384165 21KACAT Manuel D'utilisation

For cleaning machines, parts & supplies click/visit www.southeasternequipment.net

Machine Preparation

Unpacking the Machine

The machine is shipped boxed on a wooden pallet. To
unpack machine:
1. Cut and remove bands holding the box to the pallet.
2. Remove staples attaching the box to the platform at
the bottom edge of the box.
3. With two people, one at either end of the box, lift box
straight up and off machine.
4. Cut and remove bands securing the machine to the
pallet.
5. Remove back brace.
6. Remove adjustment lever, bolt, and washer from
handle.
7. Rotate handle to the user position. Then insert the
bolt through the handle bracket and handle top.
8. Place the washer and adjustment lever on the bolt.
Adjust the handle to the desired height and tighten
the adjustment lever.
For cleaning machines, parts & supplies click/visit www.southeasternequipment.net
9. Connect the battery cables to the battery.
NOTE: Connect the red cable to the (+) post and the
black cable to the (-) post.
10. Check machine fluid levels (engine oil). See
Maintenance section.
NOTE: If machine was shipped by airfreight, add
engine oil.
11. Carefully back the machine off of the pallet.

Filling the LP Cylinder

This machine uses the 20 lb (9.1 kg) capacity cylinder,
which meets the D.O.T. 4E240 standards. These
cylinders are also listed by UL. In addition, the steel
cylinder meets European TPED specifications and is CE
compliant. Filling should be done ONLY by a qualified
propane dealer. A properly filled cylinder should not
exceed 80% of the rated capacity. Do not overfill the
cylinder or use a liquid withdraw cylinder on the
machine. The use of a liquid withdraw cylinder on a
vapor withdraw system could freeze the regulator and
create a fire hazard.

Installing the LP Cylinder

Place the cylinder on the cylinder platform at the back
of the machine. Connect the fuel hose coupling to the
service valve by turning to the right (clockwise). HAND
TIGHTEN ONLY! Make sure coupling is not cross
threaded and check for leakage by noting any propane
odors immediately after cylinder is connected. Finally,
secure the tank to the machine using the adjustable
strap. Remove slack by pulling on the loose end and
securing with the velcro.
TO REMOVE THE LP CYLINDER, reverse the above
procedure. Always connect or change cylinders in a
well-ventilated area.
A10