Bosch TES 803 Serie Mode D'emploi page 27

en
Place 1 l container
Place suction pipe in container
● Place a container with a capacity of at
least 1 l under the milk frother 10.
● Place the end of the suction pipe 10d in
the container.
● Press the start button 8. The appliance
rinses twice.
Cleaning
Open powder compartment
● Open the powder compartment 18.
Insert Bosch cleaning tablet
and close drawer
● Drop a Bosch cleaning tablet in the
drawer 18 and close.
Remove filter

Info: If the water filter 29 is activated, the
display will prompt you to remove the filter
29, then press the start button 8 again.
Add 0.5 l water and descaler
● Pour lukewarm water into the empty water
tank 11 up to the "0.5 l" mark and then
dissolve two Bosch descaling tablets in it.
● Press the start button 8. The descaling
programme now runs for about
20 minutes.
Descaling
Not enough descaling fluid.
Refill fluid start

Info: If there is not enough descaling solu-
tion in the water tank 11, the corresponding
prompt is displayed. Pour in descaling solu-
tion and press the start button 8 again.
TES803_805_807_1RW.indb 23
start

start
start

Clean and refill water tank
start

● Rinse the water tank 11 and refill it with
fresh water up to the "max" mark.
● Press the start button 8. The descaling pro-
gramme now runs for about 1 minute more,
followed by the cleaning programme for
about 7 minutes, and rinses the appliance.
Descaling
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
Replace the filter if one is being used. The
appliance has completed descaling and
cleaning and is ready for use again.
Important: Wipe down the appliance using a
soft, damp cloth to immediately remove any
descaler residue. Such residue can cause
corrosion. New sponge cloths may contain
salts. Salts can cause rust film on stainless
steel and must therefore be washed out
thoroughly before use.
Thoroughly clean the suction pipe 10d of
the milk frother.
Note: If one of the service programmes is
interrupted, e. g. by a power outage, pro-
ceed as follows:
● Rinse the water tank 11 and refill it with
fresh water up to the "max" mark.
● Press the start button 8. The cleaning
programme now runs for about 3 minutes,
and rinses the appliance.
Cleaning
Empty drip tray
Replace drip tray
● Empty the drip tray 23 and reinsert it.
The appliance is ready for use again.
23
TES80.. | 04/2013
08.05.2013 14:53:03