Assembly - Fanelite 52YFT-1075 DOMINICA Mode D'emploi

8. ASSEMBLY

To fix the blades, place the motor block so that it is stable. Often, the polystyrene foam used for motor pack-
aging can make excellent support on your worktop.
1/ CHOOSE THE TUBE
Depending on the height of your ceiling, choose from the 2 tubes supplied, 13 or 25 cm. By default the black
hanger ball is installed on the 13 cm tube. If you want to use the 25 cm tube (or an optional 90 or 120 cm ex-
tension), loosen and then remove the 2 screws from the hanger ball, lower it so that you can remove the axis
then remove it from the tube. Install it on the new tube by reversing the above steps, only one way possible,
the hanger ball is installed on the side of the tube where there is an additional hole provided for the security
screw.
Ground
wire
Hole for
security screw
Hanger
ball
Axis
Tube Tube
Hanger ball
2/ ASSEMBLE THE TUBE AND CANOPY WITH THE MOTOR BLOCK
Remove the pin-pierced axis as well as the pin from the motor block and loosen the 2 screws.
Place the canopy on the tube. Pass the wires and connectors inside the tube and collect them on the other
side (if necessary remove the hanger ball so that you can pass the connectors more easily). If you have a
down rod of 90 or 120 cm, use the included cable extensions. Position the tube / canopy assembly correctly
on the motor block, and replace the bolt by passing it through the hole of the motor block and the tube (take
care to not damage the wires passing inside) then tighten the nut using a suitable wrench and put back the
pin. Tighten the 2 screws so that the tube is firmly fixed.
25