Height Under Blades; Unpacking Check - Fanelite 52YFT-1075 DOMINICA Mode D'emploi

installed and carry electricity.
A connection box is required. Never use a plastic box.
FANELITE ceiling fans can weigh up to 25 kg with accessories. Make sure that your ceiling fan hanger brack-
et is firmly attached and that your installation can support a weight of at least 68 kg.
For your own safety and that of others, please check the weight of your ceiling fan and adjust the resistance
of your installation if necessary. The ceiling fan hanger bracket must be supported by the ceiling structure.
Your installation must also be able to withstand the vibration caused by your ceiling fan when it is working.
Even a well-balanced ceiling fan causes vibration when it works.

5. HEIGHT UNDER BLADES

The minimum recommended distance between the floor and the blades is 230 cm. You can use a meter
to check this height (level of your floor / lower limit of the blades).
If the distance between the floor and the blades is less than the minimum recommended above or if the struc-
ture of your interior does not meet this minimum, check the length of the tube of your ceiling fan, it is some-
times possible to shorten it by few centimeters. Do not forget, however, that a distance of 25 cm between the
blades and the ceiling, ideally more, is needed to promote good air circulation and optimal brewing.
If, on the other hand, you need an extension down rod to lower the level of your ceiling fan (high ceiling),
please contact your retailer, there are extensions of 90 cm and 120 cm for all the models.

6. UNPACKING CHECK

Before assembling your ceiling fan, remove all parts from the package and make sure that all of the following
components are present :
Hanger
bracket
Motor
Remote control
and receiver
Wood screws and washers
(For wood ceiling)
4 blades
LED light dome
(Model with light)
Hanger studs
(For concrete ceiling)
12 screws for blades (can
be already on the motor)
Tubes 13 and 25 cm
and hanger ball
Canopy
23