Fanelite 52YFT-1075 DOMINICA Mode D'emploi page 28

3/ INSTALL THE BLADES
Slightly loosen the three screws located in the notches. Turn the LED plate counterclockwise until it unlocks.
Disconnect the LED connector in order to remove the LED plate and the bottom cover of the motor block to
be able to fix the blades.
Position each blade on the motor block and use the screws and washers provided to fix them (the screws and
washers can already be pre-mounted on the motor). Caution, tighten the screws carefully to avoid damaging
the blades, but be sure to tighten properly to prevent excessive vibration during start-up.
4/ INSTALL THE LED LIGHT DOME
Once the blades are correctly installed on the motor block, reconnect the LED connector, replace the LED
plate and the bottom cover on the motor block, insert the screws into the notches, turn until the screws lock
in the notches then tighten the screws.
Carefully install the supplied LED light dome by turning it clockwise until it locks in place.
26