Description; Assembly; Wall Mounting (Wall Fans) - Fanelite FB-50 Notice D'utilisation

All manuals and user guides at all-guides.com

3. DESCRIPTION

Before assembling your ceiling fan, remove all parts from the package and make sure that all
of the following components are present :
- Motor block
- Rear grill
- Blade
- Front grill
- Arm (wall fan)
- Tube (stand fan)
- Base (stand fan)

4. ASSEMBLY

WARNING : Before assembling your appliance, carefully read the safety instructions
in this manual.
1. Place the rear grill on the motor block and secure it with the 4 bolts and washers provided.
2. Place the blade on the motor shaft and tighten the locking screw. Check that the blade
rotates well by turning it manually.
3. Place the front grill on the rear grill and close the clips to secure the assembly.
4. For the stand fan FS-60, assemble the tube to its base using the bolt/washer kit. Once the
tube and the base are well assembled, take out the extensible part of the tube, take your fan
and insert it on the tube until it locks. Then tighten the screw to secure the assembly.

5. WALL MOUNTING (WALL FANS)

CAUTION : The fixing must be made securely in the wall STRUCTURE by a qualified
person. We can not be held liable in the event of a fall of the appliance.
Secure the arm to the wall with appropriate screws and dowels to the wall structure (the arm
can be placed up or down according to the installation requirements) :
1. Position the arm at the desired position and mark the positions of each screw.
2. Remove the arm, pre-drill the wall.
3. Re-position the arm and insert the screws and dowels.
4. Position the fan on the arm and lower the fan until it blocks.
5. Tighten the screws securely. Be sure to tighten securely for optimum safety.
12