Technical Specifications; Floor Load; Water Composition; Working Clearance - AO Smith ITS-300 Notice D'installation, Mode D'emploi, Notice D'entretien

1

1.1 Floor load

1.2 Water composition

1.3 Working clearance

1.4 General
specifications
Contents
Empty weight
Maximum floor load
Maximum operating pressure tank
Maximum operating pressure heat exchangers
Maximum water temperature tank
Maximum water temperature heat exchangers
Anodes
Table continues on the next page.

Technical specifications

Allow for the water heater's weight and the maximum floor load; refer to the table
"General specifications").
The water heater is intended for heating drinking water. The drinking water must comply with
the regulations governing drinking water for human consumption. The table gives an
overview of the specifications.
Water specifications
Water composition
Hardness
(alkaline earth ions)
Conductivity
Acidity (pH value)
Note
If the water specifications deviate from those stated in the table, then the tank protection
cannot be guaranteed (4"Warranty").
For access to the water heater, it is recommended that the following clearances are
observed:
around the anode connection: 100 cm.
•
around the water heater: 50 cm.
•
top of the water heater: 50 cm
•
ITS 300
> 1,00 mmol/l:
• German hardness > 5,6 ° dH
• French hardness > 10,0 ° fH
• English hardness > 7,0 ° eH
• > 100 mg/l CaCO
> 125 µS/cm
7,0 < pH value < 9,5
(1.4
3
Unit ITS 300
litres 289
kg 133
kg 522
kPa (bar) 1000 (10)
kPa (bar) 1600 (16)
ºC 95
ºC 110
- 1
25