Adjusting Of The Footrest - Vermeiren D200 Mode D'emploi

3.5

Adjusting of the footrest

3.5.1 Length of the footrest
L
CAUTION:
Risk of damage – Avoid that the footplate make any contact with the
ground. Keep a minimum distance from 60 mm above the ground.
3.5.2 Adjusting angle footplates
Adjust the angle of the footplates as follow:

1. Loosen bolt .
2. Adjust tube  in the desired angle. The angle indication (80°-85°-90°-95°-100°) is
according the dashes .
3. Retighten the bolt
3. Loosen the bolts
mechanism can slide over the guide
4. Pull the brake mechanism over the guide
the desired position.
5. Retighten the bolts .
6. Check working of the brakes.
7. If necessary repeat the above steps until the
brakes are adjusted well.
Adjust the length of the footrest as follow (3
positions possible: steps 35 mm → holes outside
tube, 6 positions possible: steps 25 mm → inner
tube):
1. Remove the screw
2. Adjust the length of the footrest to a
comfortable length.
3. Tighten the screw

.
Page 18

so the brake

.

.

properly.
D200
2014-08

to