Fold Up The Wheelchair; Taking Off The Wheels; Transport In The Car; Use Of The Wheelchair As Seat In A Motor Vehicle - Vermeiren D200 Mode D'emploi

2.12 Fold up the wheelchair

L
CAUTION:
Chance of pinching – Do not place fingers between the components
of the wheelchair.
1.
Fold or remove the footplates (see § 2.4).
2. Take the seat on the front side and backside and pull it up.

2.13 Taking off the wheels

To facilitate the transport off the wheelchair the rear wheels can be taken off:

2.14 Transport in the car

L
WARNING:
Risk of injury – See that the wheelchair is attached properly. So you
can avoid injury from the passengers during collision or sudden braking.
L
WARNING:
Risk of injury – Use for attaching the wheelchair and passenger
NEVER the same seatbelt.
To transport the wheelchair in the car use following steps:
1. Remove footrests and accessories.
2. Store footrests and accessories safely.
3. If possible, fold the wheelchair and remove the wheels.
4. Place the wheelchair in the luggage place.
5. If the wheelchair and the passenger compartment is NOT separated, attach the
frame of the wheelchair securely to the vehicle. You can use the available safety
belts in the vehicle.

2.15 Use of the wheelchair as seat in a motor vehicle

L
WARNING:
Risk of injury - The wheelchair may only be used as a seat in a
motor vehicle when the handgrips are placed in the lowest position. In other
cases it is forbidden to use the wheelchair as a seat in a motor vehicle.
L
WARNING:
The wheelchair has passed the crash of ISO 7176-19: 2008 and, as
such, has been designed and tested for use only as forward-facing seat in a
motor vehicle.
L
WARNING:
The wheelchair's pelvic belt alone is not suited as an occupant
restraint belt.
The wheelchair is tested using the four-point strap-tie system and a 3-point occupant-
restraint system.
1. Make sure the brakes standing in the off
position.
2. Take the wheelchair to the side frame where
you want to remove the wheel.
3. Press the button
hub.
4. Pull the wheel away from the frame.
Page 13

in the center of the wheel
D200
2014-08