Epson TM-P60II Série Manuel De L'utilisateur page 17

must be fully charged.
❏
When the battery is being charged, if the Error LED is on, an abnormality has
occurred. The battery must be replaced with a new one.
❏
Turn off the power, wait several seconds, and then turn it on again. If the
error remains, contact a qualified service person.
❏
In the label peeler issuing mode, the ErrorLED may flash when a label blocks
the label peeler detector. In this case, remove the label. If you cannot remove
the label, reload the label roll paper or press the FEED button for more than 1
second to execute a forced paper feed.
Cleaning the Thermal Head
CAUTION:
After printing, the thermal head can be very hot. Be careful not to touch it
and to let it cool before you clean it. Do not damage the thermal head by
touching it with your fingers or any hard object.
Turn off the printer, open the peeler cover and the roll paper cover, and clean the
thermal elements of the thermal head (P 23) with a cotton swab moistened with an
alcohol solvent (ethanol or IPA).
Epson recommends cleaning the thermal head periodically (generally every
3 months) to maintain print quality.
Cleaning the Platen Roller/Paper Sensor
When paper dust accumulates on the platen rollers or the paper sensor, follow the
steps below to clean them. To maintain good functional capabilities, clean them
regularly (every 6 months).
1. Turn off the printer, open the peeler cover, and then the roll paper cover.
2. Clean the platen roller and the paper sensor with a cotton swab lightly
moistened with water or alcohol. See illustration Q, R.
3. Close the roll paper cover after the water or alcohol has dried.
Cleaning the Peeler Unit
After the peeler is used for a prolonged period of time, the glue from the labels
accumulates on the rollers (S 24) of the peeler unit. If you leave the rollers in such
a condition, the glue may stick to issued labels, or a paper jam may occur. To
prevent malfunctions and maintain good print quality, clean the rollers
regularly(every 20,000 labels).
You can clean them easily if you use a label, as shown in illustration T.
Note:
Do not use any alcohol based solvents for cleaning. Such solvents may enter the roller shaft
and cause a malfunction of the peeler.
TM-P60II with Peeler User's Manual 17