Epson TM-P60II Série Manuel De L'utilisateur page 16

Note:
Removing the issued label enables the label peeler detector to detect a paper end and the
printer to issue the next label.
If the first label is not removed when using the label peeler issuing mode, the thickness of
the label and the backing paper overloads the peeler holder, possibly stopping the paper feed
motor.
When closing the peeler cover, make sure to close it firmly, pressing both ends.
See illustration M.
You can cut the label paper
When the label is completely fed to the peeling position, the printer goes in the label
removal waiting state, so remove the label.
When the label peeler detector detects the paper at the power on, the printer goes in the
label removal waiting state and the Error LED comes on. Be sure to remove the label before
powering off the printer. Otherwise, the printer goes into the label removal waiting state
when it is powered on again.
Changing the Paper Width
You can change the paper width from 29.5 to 60 mm {1.16 to 2.36"} by removing
the spacer installed in the roll paper holder and changing the setting for the paper
width. For detailed information on changing the paper width, see the TM-P60II
Technical Reference Guide.
Belt Clip
You can hang the printer on your belt using the belt clip (N 21) attached to the
back of the printer.
Wire Saddle
To prevent the USB cable from coming off the connector, attach the enclosed wire
saddle (O 22) to the printer. See illustration O.
Buzzer
The factory default is set to On (buzzer sounds) to indicate the following:
❏
Remaining battery charge is not adequate
❏
Roll paper end
❏
Error
Troubleshooting
No lights on the control panel
Check that the battery is installed.
ERROR LED is flashing or on
❏
The printer temperature may be too high. The printer resumes printing
automatically when the temperature returns to normal.
❏
Make sure that the roll paper cover is properly closed.
❏
Make sure that roll paper is installed.
❏
When the printer power is on, if the Error LED and the Charge LED are on,
the remaining battery charge is not enough for printer operation. The battery
16 TM-P60II with Peeler User's Manual