Epson TM-P60II Série Manuel De L'utilisateur page 15

5. Close the roll paper cover. See illustration F.
6. Close the peeler cover. See illustration G.
When installing the label paper vertically
Set a new roll of paper inside the roll paper cover. See ① in illustration H.
4.
Note:
Be sure that the roll paper side is at the bottom when you install the printer vertically.
Pull the leading edge of the roll paper. See ② in illustration H.
5.
Align the left edge of the roll paper with the edge of the cover. See ③ in
6.
illustration H.
Note:
Note the direction the paper comes off the roll.
7. Close the roll paper cover and the peeler cover.
When Using the Label Peeler Issuing Mode
1. Press the open button (A 9) to open the roll paper cover (A 10) and the peeler
cover (A 2).
2. Remove the used roll paper core if there is one.
3. Press the peeler switch lever (A 6) to lift the peeler holder (A 7). See
illustration I.
When installing the label paper horizontally
4. Set a new roll of paper inside the roll paper holder. Remove the first label off,
and pull the label paper so you can set the backing paper in the peeler holder
(A 7). See illustration J.
Note:
Note the direction the paper comes off the roll.
Close the roll paper cover. See illustration K.
5.
6. Close the peeler cover. See illustration L.
When installing the label paper vertically
Set a new roll of paper inside the roll paper cover. See ① in illustration H.
4.
Note:
Be sure that the roll paper side is at the bottom when you install the printer vertically.
Pull the leading edge of the roll paper. See ② in illustration H.
5.
Align the left edge of the roll paper with the edge of the cover. See ③ in
6.
illustration H.
Note:
Note the direction the paper comes off the roll.
7. Close the roll paper cover and the peeler cover.
TM-P60II with Peeler User's Manual 15