Télécharger Imprimer la page

Beurer UB 60 XXL Mode D'emploi page 12

Masquer les pouces Voir aussi pour UB 60 XXL:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
4. PURE® silver particle finishing
This electric underblanket is lined with especially soft fleece.
The topside (printed side) is finished with PURE
improves hygiene by reducing the build-up of odour and bacteria. The underblanket can
be washed as described and the finishing will not wash out.
5. Operation
5.1 Safety
CAUTION
This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated
underblanket in the event of a fault.
If the safety system has switched off the heated underblanket, the temperature setting is not illuminated
any more even when the heated underblanket is switched on.
Please note that the heated underblanket is not operable any more due to safety reasons in this case
and has to be sent to the service address indicated.
5.2 Putting into operation
Spread out the heated underblanket flat onto your mattress starting at the foot end.
Then put on your bedsheet in the usual manner so that the heated underblanket is between your mattress
and the bedsheet
CAUTION
Make sure that the heated underblanket is spread out entirely flat and that it will not rumple up or
crease when in use.
• To operate the heated underblanket connect the switch to the heated underblanket by plugging in the
connector.
• Then plug in the supply plug into the mains outlet.
5.3 Switching on
Set the ON/OFF slider (4) to the ON (I) position to switch on the electric underblanket (see Fig. switch). The
temperature settings will then light up.
5.4 Selecting the temperature setting
To increase the temperature, press the
After switching on the temperature setting is illuminated.
Setting 0:
OFF
Setting 1:
minimum heat
Setting 2-3: Individual heat
Setting 4:
maximum heat
WARNING
If the heated underblanket is used continuously (for several hours) it is
recommended to use the lowest setting of the control to avoid overheat-
ing of the user.
silver particles. This special finishing
®
button (6). To decrease the temperature, press the
12
button (7).

Publicité

loading

Ce manuel est également adapté pour:

Ub 66 xxl