Hitachi WR 8DH Mode D'emploi Et Instructions De Securite page 8

Cle a choc a batterie
Masquer les pouces Voir aussi pour WR 8DH:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

English
a.
That blades of extension cord are the same number, size, and shape as those of plug
on battery charger:
b. That extension cord is properly wired and in good electrical condition; and
c.
That wire size is large enough for AC ampere rating of battery charger as specified
in Table 1.
AC Input Rating Amperes*
Equal to or
greater than
0
2
3
* If the input rating of a battery charger is given in watts rather than in amperes, the
corresponding ampere rating is to be determined by dividing the wattage rating by the
voltage rating–for example:
9.
Do not operate battery charger with damaged cord or plug-replace them immediately.
10.
Do not operate battery charger if it has received a sharp blow, been dropped, or
otherwise damaged in any way; take it to a qualified serviceman.
11.
Do not disassemble battery charger; take it to a qualified serviceman when service or
repair is required. Incorrect reassembly may result in a risk of electric shock or fire.
12.
To reduce risk of electric shock, unplug charger from receptacle before attempting any
maintenance or cleaning. Removing the battery will not reduce this risk.
8
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
but less
than
2
3
4
1250watts
= 10 amperes
125 volts
Table 1
AWG Size of Cord
Length of Cord, Feet (Meter)
25 (7.5)
50 (15)
18
18
18
18
18
18
100 (30) 150 (45)
18
16
16
14
16
14

Publicité

Table des Matières
loading

Table des Matières